Tag Archives: cisco

CCNA 2 v6.0 Chapter 10 Exam Answers 2018

By | March 9, 2017

Cisco CCNA 2 v6.0 Chapter 10 Exam Answers 2018 Score 100% 1. A ping fails when performed from router R1 to directly connected router R2. The network administrator then proceeds to issue the show cdp neighbors command. Why would the network administrator issue this command if the ping failed between the two routers? The network administrator suspects a… Read More »

CCNA 2 v6.0 Chapter 8 Exam Answers 2018

By | March 3, 2017

Cisco CCNA 2 v6.0 Chapter 8 Exam Answers 2018 Score 100% 1. Which DHCPv4 message will a client send to accept an IPv4 address that is offered by a DHCP server? unicast DHCPACK broadcast DHCPACK unicast DHCPREQUEST broadcast DHCPREQUEST*    2. A company uses DHCP servers to dynamically assign IPv4 addresses to employee workstations. The address lease duration… Read More »

CCNA 2 v6.0 Chapter 7 Exam Answers 2018

By | February 16, 2017

Cisco CCNA 2 v6.0 Chapter 7 Exam Answers 2018 Score 100% 1. In which configuration would an outbound ACL placement be preferred over an inbound ACL placement? when the ACL is applied to an outbound interface to filter packets coming from multiple inbound interfaces before the packets exit the interface* when a router has more than one ACL… Read More »

CCNA 2 v6.0 Chapter 6 Exam Answers 2018

By | February 13, 2017

Cisco CCNA 2 v6.0 Chapter 6 Exam Answers 2018 Score 100% 1. What are three primary benefits of using VLANs? (Choose three.) security* a reduction in the number of trunk links cost reduction* end user satisfaction improved IT staff efficiency* no required configuration   2. Which type of VLAN is used to designate which traffic is untagged when… Read More »

CCNA 2 v6.0 Chapter 4 Exam Answers 2018

By | February 13, 2017

Cisco CCNA 2 v6.0 Chapter 4 Exam Answers 2018 Score 100% 1. A network designer must provide a rationale to a customer for a design which will move an enterprise from a flat network topology to a hierarchical network topology. Which two features of the hierarchical design make it the better choice? (Choose two.) lower bandwidth requirements reduced… Read More »

CCNA 2 v6.0 Chapter 3 Exam Answers 2018

By | February 9, 2017

Cisco CCNA 2 v6.0 Chapter 3 Exam Answers 2018 Score 100% 1. Which dynamic routing protocol was developed to interconnect different Internet service providers? BGP* EIGRP OSPF RIP   2. Which routing protocol is limited to smaller network implementations because it does not accommodate growth for larger networks? OSPF RIP* EIGRP IS-IS   3. What two tasks do… Read More »

CCNA 2 v6.0 Chapter 2 Exam Answers 2017

By | February 9, 2017

Cisco CCNA 2 v6.0 Chapter 2 Exam Answers 2018 Score 100% 1. What are two advantages of static routing over dynamic routing? (Choose two.) Static routing is more secure because it does not advertise over the network.* Static routing scales well with expanding networks. Static routing requires very little knowledge of the network for correct implementation. Static routing… Read More »

CCNA 2 v6.0 Chapter 1 Exam Answers 2018

By | February 9, 2017

Cisco CCNA 2 v6.0 Chapter 1 Exam Answers 2018 Score 100% 1. A network administrator enters the command copy running-config startup-config. Which type of memory will the startup configuration be placed into? flash RAM NVRAM* ROM   2. Which packet-forwarding method does a router use to make switching decisions when it is using a forwarding information base and… Read More »